![]() ![]() ![]() NOTE: The Signal Booster can be reset by disconnecting and reconnecting the power supply. ![]() If the Drive Reach Signal Booster’s light is off, verify your power supply has power. If you are not experiencing the desired boost in coverage then refer to the Troubleshooting section If you are already experiencing the desired signal boost, then no further adjustments are necessary. This is a built-in safety feature to prevent harmful interference with a nearby cell tower. This indicates that one or more of the Booster bands has reduced power due to a minor feedback loop condition called oscillation. This is a built-in safety feature that causes a band to shut off to prevent harmful interference with a nearby cell tower. This is due to a feedback loop condition called oscillation. This indicates that your Drive Reach Booster is functioning properly and there are no issues with installation.īand has shut off. This will prevent the Drive Reach from draining the battery in your vehicle. NOTE: If the 12V Cigarette Lighter port on your car is always on (even when your vehicle is turned off) and you will be parking for extended periods of time (more than a day), we recommend you turn the Booster off by pushing power cord switch to OFF position. Use only the Power Supply provided in this package. If your Drive Reach is working correctly, the light on the Booster will be green. Use the Velcro® adhesive strip/adhesive strip provided and attach to the desired location.Ĭonnect the cable from the Outside Antenna to the port labeled “Outside Antenna” on the booster and connect the cable from the Inside Antenna to the port labeled “Inside Antenna” on the booster.Ĭonnect the 12V Power Supply Cord to the end of the Booster, labeled “12V DC” then plug the power adapter into the vehicle’s 12V DC Power Supply. The location should be at least 18 inches but no more than 36 inches from where the cellular device will be used. ![]() Identify a place to mount the Inside Antenna, either on the side of the seat or on the dash and mount. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |